Change in Regulation for MWC Barcelona 2028

Independent Structural Design Principles

All stand structures must be designed following one of two clearly defined construction approaches: fully suspended or fully self-supporting.

This requirement ensures appropriate load distribution, supports engineering validation and facilitates compliance with Venue safety requirements.

Design Requirements

For the purposes of these requirements:

  • Suspended structures must be designed as fully independent systems, with all loads transferred exclusively to the approved rigging points.
  • Floor-supported structures must be designed as entirely self-supporting systems, with all loads transferred directly to the hall floor.

Suspended and floor-supported systems must remain structurally independent from one another.

Use of Rigging Points

Rigging points are intended exclusively to support approved suspended structures. They are not designed to provide:

  • Stabilisation of floor-supported structures.
  • Structural reinforcement of self-supporting systems.
  • Secondary safety support for floor-based constructions.
  • Additional support to structures anchored to or supported by the hall floor.

Non-Compliant Configurations

The following structural arrangements do not comply with the independent design approach:

  • Trusses, ceilings, frames or suspended structures that partially or fully transfer loads to pillars, towers, platforms or other stand elements supported by the floor.
  • Self-supporting structures that incorporate cables, rigging points or other suspended elements to improve stability or safety performance.

Compliant Configurations

The following configurations comply with these requirements:

  • Fully suspended structures, where the complete load is transferred exclusively to authorised rigging points, without structural contact with the hall floor.
  • Fully self-supporting structures, where the complete load is transferred directly to the hall floor, without any overhead suspension or connection to the Venue structure.

Exhibitors should adopt one of these two approaches from the initial design phase to support structural review and the installation process.

If you require any further information on these future changes, please contact our rigging team.